First, how to open multiple screens to type all operations should be playful, and should pay attention to safety. Faced with the wall station easy to use both hands, grasp both sides of the wall along the direction of the light rail to pull screen; then along the track direction of rotation of the screen. The screen should be placed onto its position, the screen is fixed. Tip: When the screen onto the intersection, you should pay attention to the track direction, and then along the rail nudge screen should be placed to its position.
Second, how much fixed to the wall with one hand hold the screen type, the other hand will handle set into the inner wall at the side of the upright hexagonal material 1100MM (the position shown in Figure 3), grasp the handle clockwise rotated 180 degrees (or continuous shaking) ;, seal retractable screens inside the pop-up screen will be fixed. The side handle into the wall recess, upwardly open screens inside lever handle telescopic seal fixed screen. After the entire group of screens in place, look at the screen is flat? Are the tracks on the same plane, if not straight up and down the stretch and then recover the seal to be adjusted until the screen straight.
Third, how to operate multi-directional retractable panel screens are usually last in each group a side wall is retractable screen, push the screen to be placed in this position, then stand at the side pulled the handle on the material within the groove Seals pop up and down (in the position shown in FIG. 1), then the handle on the wall surface of the operation hole stretch, rotate counter-clockwise direction, until the sides of the telescoping aluminum urgent wall so far.
Fourth, how to operate multi-directional style screen door door door keeper pushed to be placed in front of a screen touch position and tighten the handle into the side wall of the groove, retractable screen opens up inside lever handle side seal fixed screen. Open the door, the side door handle into the wall of another leg operation hole, flip up the lever to open the wall on the other side of the telescoping seal internal fixed screens.
Fifth, how much income to type screen 1, if a door in the door, first by playing both sides of the door of the square hole in the door is rotated 180 degrees, loosen up and down through the drive wheel seal, then shut the door in the door; 2, open The last piece of the wall of the upper and lower telescoping aluminum seal; 3, to recover the last piece telescoping aluminum screens, it can produce at least distance from the screen rotation; and 4, the screens along the rail direction nudge to close the screen position; 5, After each group of screens in the same way a good income, the two screens each compression, minimizing the distance between the screen and the screen. If necessary, to close at hiding the last piece of the plate at the top and bottom screen activity seal is opened, it is pressed against the rail and ground, so as to avoid other people just to screen out.